PAMEL Knowledge Base

Troubleshooting, tips and technical information for PAMEL devices.

Articles and solutions

19 active articles

KB0016
How to connect two heaters to one controller
If two heaters are to heat one process controlled by one controller, both should be switched and regulated together through the controller output.
GeneralPRWPRW4PRW5PRW CZECHPRD1PRD2UPRD2WIFIPRD2DCPRD2RCPRD4PRD4POWERPRD5PRMPPOWERPOWERMAXPR-HPOWER ConnectionPower control
KB0003
Probe shows an incorrect temperature, 0°C, 85°C or no reading
If the temperature displayed by the controller is clearly unrealistic, there is no reading, 0°C appears, or a constant value of 85°C is shown, first check the probe and its connection.
GeneralPRWPRW4PRW5PRW CZECHPRD1PRD2UPRD2WIFIPRD2DCPRD2RCPRD4PRD4POWERPRD5PRMTERMO4GTERMO4G / TERMO8GTERMO8GPRO Sensors and temperatureAlarms and errorsDiagnostics and service
KB0008
Controller resets or shows random temperatures - installation interference
Motors, contactors, solenoid valves, large heaters, relays, variable-frequency drives and long cables can introduce interference into the installation.
GeneralPRWPRW4PRW5PRW CZECHPRD1PRD2UPRD2WIFIPRD2DCPRD2RCPRD4PRD4POWERPRD5PRMTERMO4GTERMO4G / TERMO8GTERMO8GPRO Diagnostics and serviceConnectionAlarms and errors
KB0004
Controller continues heating after reaching the temperature - thermal inertia and probe position
Switching the heater off or reducing its power does not stop the temperature from rising immediately.
PRWPRW4PRW5PRW CZECHPRD1PRD2UPRD2WIFIPRD2DCPRD2RCPRD4PRD4POWERPRD5PRM Sensors and temperaturePower controlProcess / automation
KB0001
Correct temperature probe installation - smoker and distillation system
How to position a temperature probe correctly in a smoker and a distillation system so the controller receives a representative measurement.
GeneralPRWPRW4PRW5PRW CZECHPRD1PRD2UPRD2WIFIPRD2DCPRD2RCPRD4PRD4POWERPRD5 Sensors and temperature